I would encourage connecting the 14VDC transformer only to the Go!Control Panel DC power input. The TAKE-345 can operate on the same 14VDC transformer, but I would not recommend it. Voltage that is accepted by devices is always +/- a bit from the exact specification. See this video for an installation tutorial on the TAKE-345. Thank you for the description, it helps clarify what is being used. You are essentially just powering the TAKE directly from the Go!Control’s power transformer. On enables zone doubling (requires NX-200 zone doubling kit).Ah, I see, so you are not using a backup battery, and you are not trying to power the old panel with the transformer. On enables first to open/last to close report.ġ. On enables ground fault detection report. On enables auxiliary power overcurrent report. On enables box tamper terminals on the panel.ġ. On if manual communicator test is done during *-4-4 test function. On if manual bell test is done during *-4-4 test function. On if battery missing test is done every 12 seconds, otherwise panel tests at midnight. On if dynamic battery test performed at arming off if performed at disarming. On for immediate restore by zone off for zones to restore when the siren times out. On if siren driver should be a voltage output off if on board siren driver is enabled. Siren will blast four times when disarmed if there is an alarm in memory.ġ. On if siren blasts one time for keyswitch or wireless arming two times for disarming (must be disabled for SIA CP-01). On if siren sounds for a zone or box tamper. On if siren sounds during a cross zone verification time. On if siren sounds for telephone line cut when disarmed. On if siren sounds for telephone line cut when armed. Use this location to enable various system feature and reporting options. Location 37 has seven segments of feature selection data. Location 37 - Siren and system supervision
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |